AITRIP 3pcs BME280 Compatible with BMP280 Digital 5V Temperature Humidity Sensor Atmospheric Barometric Pressure Board IIC I2C Breakout for Arduino
Package included: 3pcs BME280 5V Temperature Humidity Sensor Atmospheric Barometric Pressure Sensor with IIC I2C Breakout for Arduino Read more Overview: BME280 is a Breakout Board featuring a Barometric Pressure Sensor TEC. BME280 Temperature, Humidity & Pressure Sensor.The breakout has selectable I2C address jumper (solder link GS2), I2C pull-up resistors, 7 pin header 2.54mm, and two mounting holes 3.5mm.It uses both I2C and SPI (supports 3-, 4-wire SPI) interfaceDefault setting of the board; single power rail Vdd=Vdd_IO (solder link GS1), pull-ups resistors (R2, R3) 10k, protocol selector resistor 0ohm (R1), decoupling capacitors 0.1uF on both power supply pins Vdd & Vdd_IO.If you connect board to both power rails VDD_IO 1.8V and VDD 3.3V be sure to remove the power rail jumper GS1 Specifications: Supply Voltage: 1.8 - 5V DCInterface: I2C (up to 3.4MHz), SPI (up to 10 MHz) Operational Range: Temperature: -40 to +85°CHumidity: 0-100%Pressure: 300-1100 hPa Resolution: Temperature: 0.01°CHumidity: 0.008%Pressure: 0.18Pa Accuracy: Temperature: +-1°CHumidity: +-3%Pressure: +-1Pa I2C address: SDO LOW: 0x76SDO HIGH: 0x77 Applications Context awareness, e.g. skin detection, room change detectionFitness monitoring / well-beingWarning regarding dryness or high temperaturesMeasurement of volume and air flowHome automation control. Control heating, ventilation, air conditioning (HVAC)GPS enhancement (e.g. time-to- first-fix improvement, dead reckoning, slope detection)Indoor navigation (change of floor detection, elevator detection)Outdoor navigation, leisure and sports applicationsWeather forecastVertical velocity indication (rise/sink speed)
Product Features
- Supply Voltage: 1.8 - 5V DC
- Interface: I2C (up to 3.4MHz), SPI (up to 10 MHz)
- BME280 5V barometric pressure digital sensor, is a new chip which was originally designed for the next generation of smartphones
- BME280 is the precision sensor, is soldered onto PCB
- It uses both I2C and SPI (supports 3-, 4-wire SPI) interface
Tags:dingo
Title - Default Title