Aoicrie MKS Gen L V1.0 3D Printer Integrated Mainboard Controller PCB Board Compatible Ramps1.4/Mega2560 R3 with A4988 Motor Driver for 3D
Product description Aiming at the problems exist on the open sourced controller board such as Ramps 1.4, the developers in Makerbase specially optimize and develop a new product, MKS Gen L, which provides more flexible choices for users. 1.Support a variety of stepper drivers such as A4988, DRV8825, TMC2100 and LV8729, available to change the stepper drivers and motors as users like. 2.Use specific power chip, support 12V-24V power input, and resolve the problems of chip heating and power shortage. 3.Stable and reliable filter circuit greatly reduces interference and avoids crashes as possible in the process of printing. 4.Use CH340 serial port chip, more easily install the drive than 16U2. 5.Run Marlin firmware, the configuration is completely same as Ramps 1.4, and available to directly replace the Ramps 1.4. 6.Support Ramps 1.4, 2004LCD,12864LCD, TFT28 and TFT32. 7.Available to input 24V, the heated bed current can be reduced to 1/4 at the same system power which effectively resolves the problem that the MOSFET of heated bed heats. 8.The stable and reliable filter circuit greatly reduces the possibility of interference, and the most likely to avoid the phenomenon of dead machine and running in the printing process. 9.Please do not insert or pull the motor and driver under the condition of power-on, which may cause the driver to burn out. Also do not adjust the current during the operation of the motor. 10.You need first disconnect the power, remove the motor, and then re-power, adjust the potentiometer, measure the voltage on the potentiometer until the measured voltage is the same as expected. Do not insert the reverse drive, otherwise it will burn out the drive and even burn the motherboard. Package Contents: 1 X MKS GEN L V1.0 Board 1 X USD Cable 5 X A4988 Stepper Motor Driver 5 X Heat Sink
Product Features
- Integrate 2560 and Ramps1.4 one PCB,which designed to avoid complicated connections, easier wiring and more stable Use high-quality 4 layer PCB&Use special power chip,support 12V-24V, also Use Run Marlin firmware,same as configuration way as Ramps1.4, it can replace Ramps1.4 directly.
- Use high quality MOSFET tube,better cooling and more stable.Use special power chip,support 12-24V input,reduce the heated bed current to 1/4 that slove the Mosfet heat problem efficiently and power shortage.
- Support a variety of stepper drivers: A4988,DRV8825,TMC2208 and TMC2100, and available to work with LCD2004,LCD12864,MKS TFT24/28/32/35 & Available to connect external large stepp drivers, A4988 driver board widely used in 3D printers and small CNC machines.
- Support functions: Non-trace resumption after power off, run out filament ,and auto shut down, XTZ axis with different color terminal controls the motors and end stop,which is convenient to wire.Use high-quality 4 layer PCB&Use special power chip.Retail Servos,AUX-1 and AUX-2 interface of Ramps1.4 provide three 5V output and three 12V output interfaces.
- Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step.Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor's rated voltage toachieve higher step rates.Use the configuration file to set the driving current mode, avoid manual adjustment of the current to cause the burned drive, convenient, safe and reliable.
Tags:workwarehouse
Title - Default Title