Size: 15cm
Purpose: dent
USE STEPS:
1. Clean concave surface.
2. High-performance glue gun, glue stick into plug-in electric heating again, does glue stick, glue will drop down in a few minutes, glue gun working temperature is about 165 ~ 200 degrees, use high temperature glue guns please pay special attention to safety and away from children.
3. Select the size of the gasket according to your body sheet metal sag, and apply it to determine the size of your choice.
4. Use the heated glue gun to evenly squeeze the open glue stick onto the surface of the gasket, and place it slightly in the hollow place for 3 minutes. Note: do not apply pressure slightly in the dent. After use, the gasket can be used again after cleaning. Please do not discard!
5. Use the balance bridge, in which you must slowly adjust the force until the dent is completely flattened and restored.
6. Spray degumming agent on the gasket and super treatment glue and remove the residual super treatment glue with the removal of film.
Note: it is important to fully recover the dent in the pit by repeatedly checking if it repeats the 3-4-5 step.
Clean the surface and barely see after repair.
Tags:
Color - Silver+Black