CERRXIAN 26cm 12V Molex IDE 4 Pin to 4 X 3/4 Pin PWM Fan Y Splitter Extension Power Sleeved Braided Cable
Product specification1.Connector A: 4 pin Molex2.Connector B: 4 X 3 / 4 Pin 3. Function: Use to connect any 3pin or 4pin (PWM Connector) fan to a 4pin molex connector. 4.Cable length:26cm5.Braided cooling fan distributor power cord helps to achieve a neat wiring solution inside your PC.6.Only the fans on the ""CPU Fan"" channel are used for monitoring.7.Compatible with all 3-pin and 4-pin fans (constant speed only).8.This is just a fan splitter cable, not a fan speed controller. The fan controller software can only adjust the 4pin PWM fan speed. The 3pin fan will run at full speed, and the speed cannot be adjusted when connected.
Product Features
- Use Molex connectors to power 3 3-Pin/4-Pin connector PC case fans to work.
- Please note that 4-pin Molex connector is the actual 2-pin, but it still works normally.Because Molex operating voltage is 12V and only requires a 2-pin connector.
- Support PWM must be 4-pin connector, but not all 4-pin motherboard connectors implement or enable PWM signal modulation by default. Please check your motherboard documentation carefully in this regard.
- This is just a fan splitter cable, not a fan speed controller. The fan controller software can only adjust the 4pin PWM fan speed. The 3pin fan will run at full speed, and the speed cannot be adjusted when connected.
- Compatible with all 3-pin and 4-pin fans (constant speed only).
Tags:electronics2022
Title - Default Title