SpeTool CNC Router Bits Carving Set for Wood Profile V Groove Engraving Solid Carbide 1/4 Inch Shank
Router Bit Set Suitable for detail profile woodwork with 1/4" shank which suit for CNC router with 1/4” collet Read more Compare the UP cut with the DOWN cut The down cut bit (left) leaves very clean edges while the up cut version (right) is far better at evacuating chips but that action can fray the edges of the cut to some degree. Up cut bits are very efficient at evacuating chips from the hole or slot it is cutting. This is especially important when the hole is ¼"-deep or more. Deep holes or grooves still have to be cut using multiple light cuts, but the upward direction of the flutes while rotating prevent the debris from building up in the hole and binding or even breaking the bit. Down cut bits require a slightly slower feed rate. This reduced pace allows the bit a little more time to throw chips out and for them to be re cut into smaller pieces that eventually are thrown from the hole or slot Read more 4 different router bit in this pack Ball Nose Router Bit Usef for 3D woodwork, detail profile carving and engrave; Tip diameter 0.5mm, 4.82 degree single side angle, 1/4" shank Down Cut Router BIt Used for clear chips down, good edge quality on top face; 1/4" cutting diameter, 1" cutting length, down cut, 1/4" shank Up Cut Router Bit Used for clear chips from the kerf left good quality on bottom face when through cutting; 1/4" cutting diameter, 1" cutting length, up cut, 1/4" shank 90 Degree Chamfer Router Bit Used for chamfering or beveling any part in a wide variety of materials. impove fluid flow and safety, to part aesthetics; 90 degree, 1/4" shank Read more 4PCS 5PCS 8PCS Shank Diameter 1/4" 1/4" 1/4"
Product Features
- The Carving router bit sets of Tapered Ball Nose, Spiral, Cone End Mill Cutter
- For CNC,Engraving machine woodworking, Carving soft and hard wood, plywood, MDF, stainless steel, titanium alloy etc
- Include 2*carbide end mills ( 1 pc v-groove end mill, 1pcs tapered end mill ), 2*Spiral router bit (1 pc up cut, 1 pc down cut)
- The Carbide End Mill Suit for CNC Router, xcarve and Makita, Bosch, and Any Brand Plunge Router with 1/4" Collet
Tags:workwarehouse
Title - Default Title